Data Envelopment Analysis application in the evaluation of efficient measurement instruments
Abstract
The following article incorporates operational efficiency analysis in the context of dimensional metrology with a focus on technology selection- the objective is to evaluate measurement technologies under similar conditions and according to the physical characteristics of the instruments. The document proposes a selection of variables that allow comparing the attributes of the measurement process in different instruments for a specific piece – in such a way that the methodology shown can be applied to pieces with similar characteristics. The instruments are within the field of dimensional metrology and are representative of those commonly used in the industrial and the academic sector in the country. The contribution of this work consists of carrying a statistical tool normally used in managing organizational operations towards a technical environment such as dimensional metrology. The results present an opportunity for future research by combining the fields of metrology and efficiency analysis.
Downloads
References
[2] Gonzalez, C., & Zeleny, R. (1995). Metrología. México: Mc. Graw Hill.
[3] Fatuzzo, G., Mangiameli, M., Mussumeci, G., & Zito, S. (2014). Laser Scanner Data Processing and 3D Modeling Usin a Free and Open Source Software. Proceedings of the International Conference on Numerical Analysis and Applied Mathematics, 780010_1- 780010_5.
[4] García-Gómez, I., Fernández de Gorostiza, M., & Mesanza Moraza, A. (2011). Láser escáner y nube de puntos. Un horizonte aplicado al análisis arqueológicos de edificios. Arqueología de la Arquitectura , 25-44.
[5] Joro, T., & Korhonen, P. (2015). Extension of Data Envelopment Analisys with Preference Information. New York: Springer
[6] Creaform. (S.F.). Creaform. Obtenido de https://www.creaform3d.com/es
[7] Midexacto. (S.F.). Midexacto. Obtenido de https://metrologiamidexacto.com/
[8] Mitutoyo. (S.F). Obtenido de http://www.mitutoyo.com.mx/
[9] Mitutoyo. (S. F). Catalogo de productos técnicos. México, México.
[10] Centro Nacional de Metrología CENAM. (Enero de 2009). Guía de Trazabilidad metrológica de los valores asignados a los calibradores y material de control de empleados por el laboratorio. México.
[11] Centro Nacional de Metrología CENAM. (2013). Guía Tecnica de Trazabilidad metrológica e Incertidumbre de Medidad en Metrología Dimensional. México.
[12] Group, A. A. (S.F.). AIAG: Automotive Industry Action Group. Obtenido de https://www.aiag.org/
[13] Sanchez, M. L., Villareal, G., & Cabrera, M. (2008). Optimización Multicriterio por Análisis Envolvente de Datos. Ingenierias, 52-59.
Copyright (c) 2019 IJRDO - Journal of Applied Science (ISSN: 2455-6653)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Author(s) and co-author(s) jointly and severally represent and warrant that the Article is original with the author(s) and does not infringe any copyright or violate any other right of any third parties, and that the Article has not been published elsewhere. Author(s) agree to the terms that the IJRDO Journal will have the full right to remove the published article on any misconduct found in the published article.
